You are here:   User Profile
Register   |  Login
Profile Avatar
JakeSchweize
3229 Glenview Drive
Corpus Christi, TX 78401
United States
361-530-2620 http://www.smallwindgenerator.com/ *******
id="mod_16410764">
Making a wind generator is a whole lot simpler than people realize. The first thing you need to be aware of is that magnets make electricity. That's right! Magnets can make electric by passing over a conductor that is inside the magnets magnetic field. This is called the law of induction discovered by Michael Faraday. All a windmill contains is magnets and copper wire. The magnets are placed on the back of the windmill propeller and pass over a winding of copper wire and it is this mechanical setup that generates the electricity. So when the wind comes along and moves the propeller it will also spin the magnets allowing electrical current to be induced onto the copper wire. The magnetic strength and the amount of copper wire surface area exposed to the magnetic field is directly proportional to the amount electricity the wind mill will put out. The speed of the propeller is also directly proportional to the electrical output.

An easy way to make a generator is to find a DC electric motor. One thing that you should know is that all DC motors are essentially electric generators. When the shaft of the motor is spun mechanically there will be an electrical output. The positive and negative of the motor is then connected to the positive and negative terminals of a charge controller. Charge controllers regulate the amount of electricity that goes to your battery bank so that it does not overcharge the batteries. Without the charge controller the batteries would probably melt or catch on fire when a big wind comes along. Should you have virtually any concerns concerning in which as well as tips on how to use small wind power, it is possible to email us in our own web site. So a charge controller is an essential safety precaution. And don't forget to attach the ground wire to a large piece of metal. It is a good idea to put your generator on top of a metal pole so you can attach the ground wire to it later on.

The output positive and negative terminals of the charge controller are then connected to the positive and negative terminals of the battery bank. A battery bank for most off grid systems usually consists of a few 12 volt car batteries. The more batteries that you have the more electricity you can store. The next step after the battery bank is the inverter.

The inverter then converts the DC electricity into AC electricity so that it can be used to power standard plug in electronics. The inverter will have AC power outlets built right into it. Some inverters have more power outlets that others. So if you are want to power a number of devices you might want to splurge on a larger inverter.





Inverter



Aickar 300W Car Power Inverter, DC 12V to AC 110V Dual AC Outlets + Dual 2.4A/24W USB Ports with Smart Fan Built-in - Blue

Buy Now



















































Wind Turbines


Was this helpful?



Yes

No

See results






Ways to spin a turbine

It is important to know that a turbine can be used in many different ways to generate electricity. The shaft of the turbine can be spun by harnessing everything from flowing water to the wind. It can even be hooked up to an exercise bike in order generate power. Use your imagination to explore innovative ways to spin a turbine and you will be rewarded with free electricity that you can use for whatever you want.





Turbine and Controller uses

If you are foreign to electricity visit my Electricity ans Electronics hub. It has the basic fundamentals that you should know about electricity before attempting a project like this. This project is good for someone who is wanting to power a small tool shed or for someone who is beginning to study alternative energy. It is also worth mentioning that it is also possible to replace the turbine in the schematic with a solar panel. All you have to do is hook the positive and negative terminals from the solar panel to the positive and negative terminals of the controller. With this system in place you can easily have your own little dual sourced power plant. The outcome of this project is very rewarding both educationally and financially.






Rate Me! 1 2 3 4 5

Cast your vote for Rate the usefulness of this article

















































Related









Solar Energy

Get Off the Grid Now #1: Build Your Own Expandable Solar Power System
by MagicStarER16








Technology

Simple Photovoltaic (Solar) Power System Setup for the Remote Home
by Emmanuel Marosi3








Renewable & Alternative Energy

Living Off The Electrical Grid By Generating Electricity On-Site At A Home Or Business
by John Coviello2








Energy-Saving Technology

How Cogeneration Can Reduce Energy Costs
by Victoria Anne1








Renewable & Alternative Energy

The Future of Wind Energy, Windmill Turbines, and Wind Farms: Beneficial or not?
by Laura Writes16




















Popular









Renewable & Alternative Energy

The Sahara Forest Project: Providing Water in the Desert
by Victoria Anne6








Solar Energy

How to Make and Use a Solar Oven | Box Cooker Plans and Recipes
by microfarmproject45








Solar Energy

How Solar Energy Becomes Electricity
by Robie Benve5


























Comments










Sign in or sign up and post using a HubPages Network account.






0 of 8192 characters used
Post Comment

No HTML is allowed in comments, but URLs will be hyperlinked. Comments are not for promoting your articles or other sites.







sending












Umesh Chandra Bhatt

5 months ago from Kharghar, Navi Mumbai, India


Interesting article. Informative. Thanks.





AUTHOR
Paul Westphal

4 years ago from Starke,FL


Sure is...electric motors are electric generators just depends on how you use them!






mikeydcarroll67

4 years ago


Informative! I never knew that they were made this way!